![]() I had to disable it in octoprint to be able to save the bed mesh, for example.Īny recommendations over these settings will be appreciated. The SAVE_CONFIG command does not save anything to the cfg file. I have a problem with Octoklipper, though. I use TMC2208 except for the extruder, where I use tmc2130 (for nothing in particular, is what I have available) Z Axis are connected to independent drivers. Note I am using TH1 and I shorted by accident TH0 and is not working in my board. #Below Macro with credit to Hywel Martin # ![]() Typically it is recommended to leave it at default value, and changing it does not noticeably affect the extruder performance. However, there is an additional parameter that affects Pressure Advance - the smooth time. Recover_velocity: 50 #allows pause resume functionality. The Klipper tuning guide suggests how to tune pressureadvance parameter. Home_xy_position: 117.5,117.5 # Change coordinates to the center of your print bed Home_xy_position: 120,120 # Change coordinates to the center of your print bed # Pins EXP2_1, EXP2_6, EXP2_2 are also MISO, MOSI, SCK of bus "ssp0" # See docs/Config_Reference.md for a description of parameters. To use this config, the firmware should be compiled for the This file has been truncated. # This file contains common pin mappings for the BIGTREETECH SKR V1.4 Note: If S is not specified and both P and T are specified, then Set acceleration: `M204 S` OR `M204 P T` Set extrude factor override percentage: `M221 S` Set speed factor override percentage: `M220 S` Use absolute/relative coordinates: `G90`, `G91` Use absolute/relative distances for extrusion: `M82`, `M83` Wait for current moves to finish: `M400` Klipper supports the following standard G-Code commands: These areĬommands that one may enter into the OctoPrint terminal tab. This document describes the commands that Klipper supports. You can read the TMC status with a command: Klipper3d/klipper/blob/master/docs/G-Codes.md#tmcxxxx # G-Codes I have repeated the procedure several times, and nothing. I indicate the steps that I am following, so that you can tell me what I am not doing well.Ġ1- Find out the current to which they are configured, for this in Mainsail, I download the *.log of klipper, I examine it and I see that: “ run_current = 0.707”Ġ2- I open the “printer.cfg” file, I examine the configuration files that are included in printer.cfg, until I find that the line run_current = 0.707, is in the Orbiter1004.cfg file.Ġ3- I edit that file, Orbiter1004.cfg, and indeed there is the line run_current = 0.707, which I change to run_current = 0.900.Ġ5- I edit the file Orbiter.cfg, to check that run_current = 0.900, that’s right, it’s changed.Ġ6 - I download the *.log of klipper again, I look for the current configuration for that motor, the extruder… AND IT HAS NOT CHANGED, it is still “ run_current = 0.707” Something strange is happening to me… I want to increase the current at which the driver that controls the extruder works…
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |